s***@interlog.com
2018-05-29 21:43:41 UTC
Hi,
Is there a way to get MPLAB X to run an .exe program *after* the device is
programmed, in the same way that it can run a program before the build (or
after the build) ?
I've made a device that switches the PGMD/PGMC lines, so they can be shared,
so it needs to be told to switch to the ICD4 for programming and then back
to the stuff on the PCB for testing.
If I can't figure anything else I can put a long delay in the device firmware
to do the switching, but it would be nice to have it go back right after the
programming operating completes.
Thanks!
--
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
Is there a way to get MPLAB X to run an .exe program *after* the device is
programmed, in the same way that it can run a program before the build (or
after the build) ?
I've made a device that switches the PGMD/PGMC lines, so they can be shared,
so it needs to be told to switch to the ICD4 for programming and then back
to the stuff on the PCB for testing.
If I can't figure anything else I can put a long delay in the device firmware
to do the switching, but it would be nice to have it go back right after the
programming operating completes.
Thanks!
--
http://www.piclist.com/techref/piclist PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist